水中总氮测定方法存在问题的研究及改进

碱性过硫酸钾消解紫外分光光度法测定水中总氮采用的消解器皿是玻璃比色管,易造成空白偏高、结果偏低等问题。采用双圆柱状的消解杯对水样进行消解。结果表明,消解杯消解水中总氮,线性相关系数均大于0.999,检出限为0.05 mg/L,相对标准偏差小于5%,相对误差为0.88%~1.00%;改进后的消解器皿具有较好的精密度和准确度,能够更加准确测定水中总氮的含量。     

Effects of bed materials on the performance of an anaerobic sequencing batch biofilm reactor treating domestic sewage

The objective of this study was to determine the best performance of an anaerobic sequencing batch biofilm reactor (AnSBBR) based on the use of four different bed materials as support for biomass immobilization. The bed materials utilized were polyurethane foam (PU), vegetal carbon (VC), synthetic pumice (SP), and recycled low-density polyethylene (PE). The AnSBBR, with a total volume of 7.2L, was operated in 8-h batch cycles over 10 months, and fed with domestic sewage with an average influent chemical oxygen demand (COD) of 358+/-110mg/L. The average effluent COD values were 121+/-31, 208+/-54, 233+/-52, and 227+/-51mg/L, for PU, VC, SP, and PE, respectively. A modified first-order kinetic model was adjusted to temporal profiles of COD during a batch cycle, and the apparent kinetic constants were 0.52+/-0.05, 0.37+/-0.05, 0.80+/-0.04, and 0.30+/-0.02h(-1) for PU, VC, SP, and PE, respectively. Specific substrate utilization rates of 1.08, 0.11, and 0.86mg COD/mgVS day were obtained for PU, VC, and PE, respectively. Although SP yielded the highest kinetic coefficient, PU was considered the best support, since SP presented loss of chemical constituents during the reactor's operational phase. In addition, findings on the microbial community were associated with the reactor's performance data. Although PE did not show a satisfactory performance, an interesting microbial diversity was found on its surface. Based on the morphology and denaturing gradient gel electrophoresis (DGGE) results, PE showed the best capacity for promoting the attachment of methanogenic organisms, and is therefore a material that merits further analysis. PU was considered the most suitable material showing the best performance in terms of efficiency of solids and COD removal.     

污泥加热预处理对中温厌氧消化的影响

对污泥加热预处理给中温厌氧混合消化和污泥单独消化带来的影响进行了研究.研究结果表明,污泥加热预处理有利于提高混合消化对 COD 的去除率,尤其是 SCOD 的去除率由 77%增长到 93%,但不利于 TS 和 VS 的去除;而对污泥单独消化,预处理则不利于有机物的去除.采用加热预处理后的污泥进样,混合消化和污泥单独消化的甲烷产气量均有所提高.     

废旧阴极-赤泥协同处理烧结熟料的溶出性能

采用XRF,ICP-MS,XRD及SEM-EDS检测手段,研究了废旧阴极-赤泥高温协同处理所得熟料的溶出性能.结果表明,Na₂CO₃浓度,温度,时间及液固比因素对Al₂O₃,Na₂O溶出率TFe₂O₃的富集效果的影响趋势一致.最适宜溶出条件为：Na₂CO₃ 30g/L,温度50℃,时间30min,液固比8.该条件下,熟料中Al₂O₃和Na₂O溶出率分别高达为87.41%和92.51%;相应的SiO₂和CaO溶出率仅为3.02%和0.36%,铁矿物几乎不溶.溶出渣中的TFe₂O₃含量从熟料中23.64%提高到39.89%,研究表明溶出工艺同步实现了熟料中铝、钠的回收和铁的富集.再者,处理后溶出渣较熟料减量近16%（以铝和钠溶出率测算）,且属于非危险性废物.     

有机垃圾厌氧消化泡沫产生机理及控制方法

为了分析厌氧消化泡沫的产生机理和控制方法有助于解决有机垃圾厌氧消化起泡问题,本文调研了近年来报道的厌氧消化系统起泡现象,并从底物特性、反应器构造及运行条件和消化过程相关特性3方面分析了不同底物、工艺和环境条件下厌氧消化反应器的起泡机理;讨论了丝状菌指数、表面张力、粘度、有机负荷、起泡趋势和泡沫稳定性等参数作为起泡风险评价指标的合理性;介绍和比较了4类消泡方法（物理法、机械法、生物法和化学法）的消泡原理及优缺点.目前,除污泥厌氧消化系统外,其他有机垃圾厌氧消化系统起泡的主要因素尚不明确,而这也限制了泡沫控制方法的开发.后期探索关键起泡微生物或研究生物表面活性物质与起泡的相关性,将有助于从新的角度揭示起泡机理,并开发出针对性更强的泡沫控制方法.     

大气沉降向华中丘陵区稻田输入硫通量的观测

选取我国华中丘陵区的湖南省长沙县一个典型水稻种植区,对2015与2016年2年雨水样中的SO₄²-S和大气SO₂的沉降量进行监测,分析雨水中SO₄^2-、NO₃^-的关系,解析大气硫沉降的主要来源.结果表明,研究区大气中SO₂-S和雨水中SO₄^2--S的年均浓度分别为8.5 μg/m³和1.1mg/L,大气硫沉降年均总量为26.8kgS/（hm²·a）,其中年均降雨混合沉降量18.2kgS/（hm²·a）,年均干沉降量为8.6kgS/（hm²·a）.研究区域硫素干、混合沉降量存在明显的季节差异,硫素混合沉降春季高于夏、秋、冬季,而硫素干沉降冬季高于春、夏、秋季.雨水中NO₃^-/SO₄^2-的质量比大多小于1,表明研究区大气硫素主要来自固定污染源（燃煤）.华中丘陵区稻田具有较高的硫沉降,但硫沉降量已较21世纪初出现了较大幅度下降,农业生产中需要根据农田硫素收支状况酌情补充硫肥来保证作物高产稳产.     

微波消解-ICP-OES联合测AZ61镁合金中Zn、Mn、Al的不确定度分析

目的研究AZ61镁合金中合金元素成分分析过程中的不确定度因素,以提高分析结果的准确性。方法采用微波消解仪消解样品,以电感耦合等离子体发射光谱仪(ICP-OES)测定AZ61镁合金中锌、锰、铝元素的含量。分析测试过程中产生不确定度的因素,并且进行评定和计算。结果采用微波消解-ICP-OES法测定镁合金中锌、锰、铝元素的含量时,测量不确定度主要由样品溶液稀释、移液枪、标准曲线以及测试的重复性引起,AZ61镁合金主要的合金成分为锌(1.1270%±0.0433%)、锰(0.1797%±0.0064%);铝(6.4468%±0.2029%)。结论对分析过程中产生的不确定度因素进行分析及评定,可以确保分析结果的可靠性以及准确性,从而更好地控制镁合金的性能,提高镁合金的装备环境适应性。     

微波高压络合消解石墨炉原子吸收分光光度法测定环境空气中锑

用有机滤膜采集空气中颗粒物样品,用微波高压络合消解后制成样品溶液。用石墨炉原子吸收分光光度法可确定样品溶液中锑的浓度。该方法具有对有机滤膜和样品消解完全,省时,无损失,灵敏度高,准确度、精密度好等特点。     

A Global Overview of Atmospheric Acid Deposition Fluxes

This paper presents a summary of globalacid deposition flux data taken from a globalassessment report on acid deposition prepared forUNEP/WMO (Whelpdale and Kaiser, 1996). There is a largevariation in the spacial coverage and reliability ofmonitoring around the world. Many more stationsmeasure wet deposition than collect appropriate datafor estimating dry deposition. The widespread regionswith highest precipitation concentrations anddeposition fluxes of sulphate and nitrate coincideclosely with the regions of highest density ofSO₂ and NO_x precursor emissions occurringprimarily in the mid-latitude, northern hemispherebelt where a large fraction of the worlds fossilfuels is consumed. Organic acids in precipitation makea minor contribution to acidity (<20%) inindustrial regions, but in the rest of the world theyare of same order, or even exceed, inorganic acids.Less is known about dry deposition, but it appears topredominate near strong emission sources with wetdeposition predominating farther downwind. The molarratio of the N/S contribution to acidic deposition isclose to 1.0 over large areas of Europe and NorthAmerica, but is highly variable elsewhere, beinghighest in equatorial regions due to biomass burningand lowest near smelters and other large sources of SO₂.     

高压密封消解-流动注射同时测定海水中总氮和总磷

建立了高压密封消解-流动注射同时测定海水中总氮和总磷的方法,方法采用特制聚四氟乙烯密封消解罐,经高压消解锅消解后,用流动注射分析仪同时测定海水中的总氮和总磷。结果显示,总氮和总磷在0~3.20 mg/L范围内线性良好,总氮相关系数(r)=0.9997,检出限为0.012 mg/L,相对标准偏差为0.65%~2.59%,加标回收率为97.8%~102%;总磷相关系数(r)=0.9999,检出限为0.006 mg/L,相对标准偏差为0.50%~6.67%,加标回收率为98.8%~101%。该方法可同时测定海水中总氮和总磷,方法准确度和精密度良好,满足分析要求,适用于大批量海水样品中总氮和总磷的快速准确定量。